Life Fitness Model TR9700, TR9500, TR9100 Treadmills
How To...Replace or Install Rear Roller Guards
Tools Required: Philips Screwdriver
NOTE: The following steps are applicable to units with Configuration No. 1, Rear Roller Guards.
1. Remove the Screws securing the Rear Roller Guard Assembly to the Frame.
Screw
Cover Guard
Grommet
Roller Guard, RT
Roller Guard, LT
Grommet
Screw
Configuration No. 1
2. Remove the old Grommets from the Rear Roller Welded Guard Tab and Base Frame (model
specific).
3. Install the new Grommets (included in kit) in the Rear Roller Guard Weldment and Base Frame
locations.
4. Place new Roller Guard in position as shown with the top surface under walking belt. Align mounting
holes.
Roller Guard to be
Align mounting holes
located between belt
with grommet holes
and deck
Life Fitness Model 97Ti, 95Ti, 93T Treadmills
How To...Replace or Install Rear Roller Guards
Tools Required: Philips Screwdriver, Flat Blade Screwdriver
NOTE: The following steps are applicable to units with Configuration No. 2, Rear Roller Guards.
1. Remove existing Roller Guard by unscrewing mounting screws on top and base of frame.
Mounting
Screws
2. With flat blade screwdriver, remove Grommet and Washer, discard old washer and re-install the
grommet. Use caution to prevent injury or damage to paint.
NOTE: Do not replace washer. Having a washer and the grommet will raise the guard too high
and cause rubbing against the belt resulting in premature wear and reducing belt life.
3. Remove the Base’s Lower Head Grommet for the base bottom hole and move to the upper hole in
the Base Frame.
Life Fitness Model 97Ti, 95Ti, 93T Treadmills
How To...Replace or Install Rear Roller Guards (Continued)
4. Place new Roller Guard in position shown with top surface under walking belt. Align mounting holes.
Roller Guard to be
located between belt
and deck
Align mounting holes
with grommet holes
5. Install Screws and fasten securely. Approx. 22-37 in/lbs.
6. Repeat steps for opposite side. After completion run treadmill and check for interference or binding. If
needed loosen Mounting Screws, re-align Guard, and refasten securely.
Secure Mounting
Screws
M051-00K58-A128
|
Lennox Hearth Gas Heater L20 BF 2 User Manual
Lightolier Indoor Furnishings 1000LVRE1 User Manual
Magnavox Clock Radio AJ3930 User Manual
Magnavox Flat Panel Television 42MF7000 User Manual
Manitowoc Ice Ice Maker K00385 User Manual
Meridian America Portable Speaker A200Z User Manual
Metra Electronics Automobile 99 7579 User Manual
Metra Electronics Car Stereo System 99 8711 User Manual
Metrologic Instruments Scanner MS700i User Manual
Middleby Marshall Oven SPL092606 PF BD User Manual